JLG M4069 Service Manual - Manual (Page 94)

SECTION 5 - JLG CONTROL SYSTEM
5-2 – JLG Lift– 3121639
Using the Analyzer:
With the machine power on and the analyzer connected
properly, the analyzer will display the following:
HELP:
PRESS ENTER
At this point, using the RIGHT and LEFT arrow keys, you
can move between the top level menu items. To select a
displayed menu item, press ENTER. To cancel a selected
menu item, press ESC; then you will be able to scroll
using the right and left arrow keys to select a different
menu item.
The top level menus are as follows:
HELP
DIAGNOSTICS
ACTIVATE TESTS
ACCESS LEVEL
PERSONALITIES
MACHINE SETUP
CALIBRATION: (Access level 1 only)
If you press ENTER, at the HELP:PRESS ENTER display,
and a fault is present, the analyzer display will scroll the
fault across the screen. If more than one fault is present
only the highest priority fault will show. The other active
faults are viewable in Logged Help. If there was no fault
detected, the display will read:
In platform mode:
HELP:
EVERYTHING OK,
In ground mode:
HELP:
GROUND MODE OK
If ENTER is pressed again, the display moves to the fol-
lowing display:
LOGGED HELP
1: STARTUP (2/1): (Or last recorded fault)
At this point, the analyzer will display the highest priority
active fault, if any are present. You may scroll through the
fault logs to view what the last 15 faults were. Use the right
and left arrow keys to scroll through the fault logs. The
active faults, are listed before the first POWER CYCLE. To
return to the top menu, press ESC two times.
When a top level menu is selected, a new set of menu
items may be offered; If for example you choose Personal-
ities:
DRIVE
LIFT
STEER
JOYSTICK
Pressing ENTER with any of the above displayed menus,
will display additional sub-menus within the selected
menu. In some cases the next level is the parameter or
information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may
only view the personality settings for selected menus
MENU:
HELP:PRESS ENTER
log:
1:Startup(2/1)