Echo SHC-225S Serial S86111001001 - S86111001676 - Manual (Page 13)

H
edge
C
lipper
O
peratOr
'
s
M
anual
13
WARNING
The blades must not move at idle, otherwise serious personal in-
jury may result. Periodic carburetor adjustment may be necessary
to assure blades do not move at idle.
If blades move, readjust carburetor according to “Carburetor Ad-
justment” instructions in this manual or see your ECHO Dealer.
6. Throttle Trigger
After engine warm up, grip throttle handle with right hand and
support handle with left hand. Depress throttle trigger lockout, and
gradually depress throttle trigger to increase engine RPM to operat-
ing speed.
startInG warm enGIne
The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not depress throttle trigger to wide open position.
WARNING
The blades must not move at idle, otherwise serious personal in-
jury may result. Periodic carburetor adjustment may be necessary
to assure blades do not move at idle.
If blades move, readjust carburetor according to “Carburetor Ad-
justment” instructions in this manual or see your ECHO Dealer.
1. Stop Switch
Move Stop Switch button (A) away from the STOP position.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear
of all obstacles. Firmly grip throttle handle and throttle trigger lock-
out with left hand. Rapidly pull recoil starter handle/rope (D) until
engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
A
C
D