Echo SHC-225S Serial S86111001001 - S86111001676 - Manual (Page 22)

22
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: Torx T27 L-Wrench, screwdriver, clean rag, small
brush
Parts required: POWER BLENDX TM 14 oz. cartridge or Lithium
Based Grease
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Loosen gear housing assembly locating screw (A) and mounting
screws (C). Remove the gear box from the drive shaft housing.
2. Pull the drive shaft (B) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful not to
get dirt on the flex shaft.
4. Install the gear housing assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
D
sharpenInG blades
Level 3.
Tools required: Flat file, screwdriver
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.