Danger – Despatch Stackable LCC/LCD User Manual
Page 32
A
SSEMBLY
&
S
ETUP
Stackable LCC/LCD Oven
Owner’s Manual
32
Version 26
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
4. Loosen the two screws at the upper and lower corners of the right rear of the chamber
a. Pull out the shelf support/duct as a single unit and set it aside.
5. Note the position of the threaded rods behind the duct assembly on the right side. The
HEPA filter will be fitted over these rods.
6. Remove the brass nuts and washers from the rods that are temporarily locking the
rods to the oven wall.
a. Reuse these nuts to hold the filter in place.
7. This step for the LCC1-16-3 only:
a. Remove filter frame to be reinstalled after filter.
b. Remove the HEPA filter (shipped separately) from its container.
c. NOTE: The seal side goes toward the wall of the oven.
i. Place the filter inside the chamber and install filter mounting frame
over rods.
ii. Push filter tight to rear wall with mounting frame.
Danger!
Make certain power is disconnected from the oven before
removing or replacing the HEPA filter.
Remove shelves before installing HEPA FILTERS
Loosen threes screws to remove the entire inner
casing assembly as a single unit.
Loosen ¼ turn using
5/16 inch nut driver.
Figure 11. Remove inner casing to install HEPA filter.