Despatch Stackable LCC/LCD - Manual (Page 40)

O PERATION Stackable LCC/LCD Oven Owner ’s Manual
40 Version 26
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

The amber beacon light will be ON (steady) until the profile is
started (at the completion of Step 5).
3. Place the product on the shelf in the oven.
4. Close the oven door.
5. Run the desired profile with the Protocol Plus Controller.
a. Press Select until Profile is displayed.

Press Run at any time to active the Profile Mode.
b. Press ▲ or ▼ to display the desired profile.
c. Press Run to start the Profile Mode.

After pressing Run, the display changes from Stop to Run.
Segment time remaining and Current Segment number will
display.
6. At this point, the oven profile cycle is in process and the door is locked.
a. The green beacon light is ON (steady), the amber beacon light is off.
b. When the process is complete, the amber beacon should be ON, and the
DOOR
RELEASE pushbutton light is on.
7. Press DOOR RELEASE pushbutton
8. Open the oven door to remove the product workload.
9. Closes the oven door to complete the process cycle. The oven is ready for the next lot.