ElmoMC SimplIQ Analog Servo Amplifiers-Cymbal - Manual (Page 7)

Cymbal Installation Guide Safety Information
MAN-CYMIG (Ver. 1.3)
7
1.1. Warnings
• To avoid electric arcing and hazards to personnel and electrical contacts, never
connect/disconnect the servo drive while the power source is on.
• Power cables can carry a high voltage, even when the motor is not in motion. Disconnect
the Cymbal from all voltage sources before it is opened for servicing.
• The Cymbal servo drives contain grounding conduits for electric current protection. Any
disruption to these conduits may cause the instrument to become hot (live) and dangerous.
• After shutting off the power and removing the power source from your equipment, wait at
least 1 minute before touching or disconnecting parts of the equipment that are normally
loaded with electrical charges (such as capacitors or contacts). Measuring the electrical
contact points with a meter, before touching the equipment, is recommended.
1.2. Cautions
• The Cymbal servo drives contain hot surfaces and electrically‐charged components during
operation.
• The maximum DC power supply connected to the instrument must comply with the
parameters outlined in this guide.
• When connecting the Cymbal to an approved 12 to 95 VDC auxiliary power supply, connect
it through a line that is separated from hazardous live voltages using reinforced or double
insulation in accordance with approved safety standards.
• Before switching on the Cymbal, verify that all safety precautions have been observed and
that the installation procedures in this manual have been followed.
www.elmomc.com