HYDAC ETS 3000 - Manual (Page 32)

ETS 3000 User Manual 05 Sep 2008
8
7.2
Overview of the Basic Settings
Setting Display Setting
range Initial
(default)
setting
Switching mode, switching output 1 (Sm 1):
Switching output 1 is operating in
switching point / hysteresis mode.
Switching output 1 is operating in
window mode.
SP/ Win SP
Switching direction, switching output 1 (S 1)
Normally open mode.
Normally closed mode.
ON/ OFF ON
Switch-on delay, switching output 1 (Ton 1)
Time in seconds which must elapse once the
particular switching point has been reached or
exceeded before switching will occur.
0.00–99.99s 0
Switch-off delay, switching output 1 (Toff 1)
Time in seconds which must elapse once the
temperature has fallen below the particular switch-
back point before switching will occur
.
0.00–99.99s 0
Switching output 2, as described above.
Primary display (Primary)
Value which is to be continually displayed:
Actual temperature
Temperature, peak value
Temperature, lowest value
Display switched off
or Switching point 1 or 2
(for function, see section 4 Digital Display)
ACT/
Top/
Min/
OFF/
S.P.1/
S.P.2/
ACT