Brother NC9100H - Manual (Page 126)

INTERNET FAX (MFC ONLY) 12 - 5
If you specify more than 16 characters, the LCD panel will scroll the
name to the left character by character. You can enter up to 60
characters.
1 Press Start to send the document.
After the document is scanned, it is transmitted to the Recipient
Internet Fax Machine automatically via your SMTP server. You can
cancel the send operation by pressing the
Stop/Exit button during
scanning. After the transmission is finished, the machine will return
to standby mode.
Some E-mail servers do not allow you to send large E-mail
documents (the System Administrator will often place a limit on the
maximum E-mail size). You can enable the Limit Size of the Sent
Mail feature. The machine will display Out of Memory when trying
to send E-mail documents over 1Mbyte in size. The document will
not be sent and an error report will be printed. The document you are
sending should be separated into smaller documents that will be
accepted by the mail server. You can turn on this feature through the
Web Management utility or the LAN function mode.
Receiving E-mail or Internet Fax
There are 2 ways you can receive E-mail messages:
■
POP3 receiving at regular intervals
■
POP3 receiving (manually initiated)
Using POP3 receiving the MFC must poll the E-mail server to receive
the print jobs. This polling can occur at set intervals (for example, you
can configure the MFC to poll the E-mail server at 10 minute
intervals) or you can manually poll the server by pressing the
Shift
+ Start button.
If your MFC starts to receive E-mail print jobs, the LCD panel will
reflect this activity. For example, you will see Receiving on the
LCD panel followed by “xx MAIL(S)”. If you press the
Shift + Start
buttons to manually poll the E-mail server for E-mail print jobs and
there are no mail documents waiting to be printed, the MFC will
display No Mail on the LCD panel for two seconds.