MacDon D60 Draper Headers - Manual (Page 135)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 133 Revision B
8.9.12.3 Removal - Plastic Fingers
a. Remove screw (A) with TORX-Plus 27 IP socket
wrench.
b. Push finger top clip back toward reel tube, and
remove from finger tube.
8.9.12.4 Installation - Plastic Fingers
a. Position finger on rear of finger tube, and engage
lug at bottom of finger in lower hole in finger tube.
b. Gently lift top flange, and rotate finger until lug in
top flange engages upper hole in finger tube.
IMPORTANT
Do not apply force to finger prior to
tightening mounting screw.
Applying force to finger without screw
tightened will break finger or shear off
locating pins.
c. Install screw (A), and torque to 75 - 80 in·lbf
(8.5 - 9.0 N·m) with a TORX-Plus 27 IP socket
wrench.
A
A
REMOVAL
INSTALLATION