MacDon D60 Draper Headers - Manual (Page 86)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 84 Revision B
8.5.2 LUBRICATION POINTS (Cont’d)
SICKLE HEAD
1 PLC - SINGLE KNIFE
2 PLCS - DOUBLE KNIFE
NOTE
To prevent binding and/or
excessive wear caused by sickle
pressing on guards, do not
over- grease. If more than 6 to 8
pumps of the grease gun are
required to fill the cavity, replace
the seal in the sickle head.
FRAME/WHEEL PIVOT (1 PLC) BOTH SIDES
NOTE
Check for signs of excessive
heating on first few guards after
greasing. If required, relieve
pressure by depressing check-
ball in grease fitting.
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2). Lithium Base