SATEC PM130 PLUS Manual - Manual (Page 69)

‎Chapter 5 Configuring T H E P M 1 3 0 P L U S
Configuring C O M M U N I C A T I O N S
PM130 PLUS Powermeter Series 69
Figure ‎5-4: eXpertPower Client Setup Tab
The following table lists available options. Refer to your eXpertPower
service provider for the correct network settings.
Table 17: eXpertPower Client Setup Options
Parameter Options Default Description
XPW Server IP Address 207.232.60.18 The IP address of the
eXpertPower server
XPW Server Port 0-65535 5001 The TCP service port of the
eXpertPower server
XPW Client Enabled NO, YES NO Enables operations of the
eXpertPower client
Time to Next Session,
min
1-99999 The time remaining to the
next connection session
NOTES
1. Do not enable the eXpertPower client in
your meter if you do not use the
eXpertPower
TM service.
2. Do not change the connection time setting. It is for information
only. The eXpertPower server updates it automatically.
Setting Up TCP Notification Client
The TCP notification client can establish connections with a remote
Modbus/TCP server and send notification messages either on events, or
periodically on a time basis.
To set up communications with a remote TCP Notification server, select
Communication Setup from the Meter Setup menu, and then click on
the TCP Notification Client Setup tab.