WORX WU469 600W Contour Jigsaw 240V - Manual (Page 12)

12
you need.
PARALLEL GUIDE FIXTURE
Slide the parallel guide arm through both fixtures to achieve the
required cutting distance and tighten both screws to lock into
position.
ROLLER GUIDE (See Fig. E)
Ensure the blade is located and runs smoothly in the groove
otherwise the pendulum function will not work correctly and the
blade will not be supported during cutting.
PENDULUM ACTION CONTROL (See Fig. F)
The pendulum action varies the forward cutting angle of the blade
for increased cutting efficiency. This can also be adjusted during
no load running. Refer to the chart 2 for more details. Do not use
excessive blade force when cutting with the pendulum action. The
blade cuts on the upward stroke only.
Chart 2
0
Thin materials. Fine cuts. Hard materials, (e.g. steel &
chipboard)
I Thick materials (e.g. wood) & plastic
II
Fast cuts (e.g. softwood). Cutting in the direction of the
wood grain.
5
6
7
E F
G