WORX WU469 600W Contour Jigsaw 240V User Manual
Page 13
13
BASE PLATE
Adjusting the angle of the base plate
(10)
enables bevel cutting.
The base plate must always be held firmly against the materials
being cut to reduce saw vibration, blade jumping or blade breakage.
BASE PLATE ANGLE ADJUSTMENT (See Fig. G)
Use a hex key. Loosen the bolts securing the base plate. For preset
angles, adjust the press-board arrow pointing at the desired angle
(0,15,30,45) on the angle plate (See Fig. G). For other mitre angles,
rotate to your desired angle (use a protractor scale). Following one
of the above procedures, hold the base plate in position and firmly
tighten the bolts to clamp the base plate at that angle. Finally,
check the angle and ensure the base plate is firmly clamped. The
angle markings on the base plate are accurate for most general
purposes but it is recommended for accurate work to set the angle
with a protractor and make a test cut on other material.
VACUUM ADAPTOR (See Fig. H)
The adapter
(4)
rotates anti-clockwise inside the dust tube and
locks in position by a groove inside the dust tube The adapter must
then be connected to a suitable external dust extraction machine.
PROTECTION FINGER
The finger is located in front of the blade holder. Whilst working, it
8
9
10
11
H