Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 95)

87 Publication 1784-UM003A-EN-P – June 2003
Chapter
6
Naming & Configuring Your Motion Axis
This chapter describes how to name, configure, and edit your axis properties.
Be careful while reading this information. Many of the screens appear to be
the same (and many are) but some of the screens change in content based on
the type of axis. They are labeled where different so read through the entire
section to make sure you find the explanations for the type of axis selected.
Naming an Axis Naming an axis adds it to your application. To name an axis:
Go to the File pull-down menu, select New Component, and then select
Tag.
Figure 6.1 File Menu to New Component to Tag