Rockwell Automation 2705-ND1 Keypad Development Software - Manual (Page 12)

Chapter 3
Installing the Software
3–2
2. Insert the 5 1/
4
” or 3 1/
2
” installation disk into the floppy drive. Normally,
this is the A drive.
3. Change to the A drive. Type a: and press [Enter].
C:> a: [Enter]
A:>
The A> prompt indicates that you have switched to the A drive.
4. Start the installation procedure by typing install and pressing [Enter] .
A:> install [Enter]
The installation procedure displays on your screen as it executes. Follow
the instructions until the installation is complete.
The procedure creates a subdirectory into which all of the program files
are installed. This is the directory from which you will execute and run
the software.
5. When the installation is complete, you return to the A:> prompt.
6. Change back to the C drive. Type c: and press [Enter].
A:> c: [Enter]
C:>
7. Use the CD command to move to the \KEYPAD subdirectory (or the
alternate directory specified during installation).
C:> cd \keypad [Enter]
C:\KEYPAD>
8. To run the software, type keypad and press [Enter].
C:\KEYPAD> keypad [Enter]
The copyright screen displays. Press any key to access the main menu.