Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 45)

5–4 Using ODS for Project Management
Publication MCD-5.1 -August 1999
If your control type is 9/PC (the default selection for
Communication Mode is PC to 9/PC ), the following steps must
be completed:
A. Enter the location of the 9/PC host computer in the text box.
The host computer is the computer name on the network
where the 9/PC is installed. This name should typically be
20 characters or less. “Local” (or the name that you enter)
denotes the default location of your host computer where
your 9/PC is installed. Once you enter the location, select
[ENTER] .
Important: The explanation of “Local” in step A. assumes
that ODS and 9/PC are installed on the same PC.
If your host computer is a computer that 9/PC
and ODS is not installed on, refer to page 6–12.
B. By default, CNC_1 will appear in the box as the 9/PC topic
name. This is the name of your selected CNC. If this topic
name is incorrect, enter a new name in the text box.