Bully Dog 40605 John Deere 8030 and 8020 Series Module - Manual (Page 6)

5
4. Plug tractor male plug into module female plug
5. Plug the module male plug into the tractor MAP
sensor.
6. Continue routing module cable along the wiring
harness above the engine. Run the cable down be-
tween the engine block and starting fluid can to the
location shown.
7.: Disconnect the plug from the factory fuel rail pres-
sure sensor.
Fuel Rail Pressure Sensor
Module Female Plug
Module cable run
Module Male Plug
rPm inSTAllATiOn
Warning: There might be a tamper resistant
sleeve that needs to be removed from the Fuel rail
pressure sensor. If applicable, remove carefully as
to not void the tractor’s warranty.