Metrohm 756 KF Coulometer - Manual (Page 83)

4.2 Remote control commands
756/831 KF Coulometer, Instructions of Use 75
.ExtrT: Extraction time in s. During this time controlling occurs but the ti-
tration will not be stopped.
4.2.2.8. Mode.Parameter.TitrPara.StartDrift 1...20..999
StartDrift in ug/min. Drift for "conditioning ok" and start of titration possible.
4.2.2.9. Mode.Parameter.TitrPara.Ipol 2, 5, 10, 20, 30
Mode.Parameter.TitrPara.PolElectrTest ON, OFF
.Ipol: Selection of polarization current.
If the test for polarized electrodes is switched on, it is performed on change-
over from the inactive state to an active state (titration or conditioning).
4.2.2.10. Mode.Parameter.TitrPara.Temp -170.0...25.0...500.0
Titration temperature in °C.
4.2.2.11. Mode.Parameter.TitrPara.TDelta 1...2...999 999
Time interval in s for the entry of a measurement point in the list of measured
points.
4.2.2.12. Mode.Parameter.TitrPara.TMax 1...999 999, OFF
Maximum titration time in s. After this time, the titration will be stopped.
4.2.2.13. Mode.Parameter.Statistics.Status ON, OFF
Mode.Parameter.Statistics.MeanN 2...20
Mode.Parameter.Statistics.ResTab.Selected original, delete n,
delete all
Mode.Parameter.Statistics.ResTab.DelN 1...20
Entries for the statistics calculations.
.Status: On/off switching. Requirement for statistics calculations is a valid
assignment, see 4.2.2.26.
.MeanN: Number of individual results for statistics calculations.
.ResTab.Select: Selection of the table for the statistics calculations.
original: Original table. The original table is (again) set up, i.e. any
individual results which have been deleted are reincorporated
in the statistics calculations.
delete n: Single result lines are removed from the statistics calcu-
lation. All results of the corresponding line in the statistics
table are deleted. Specification of the line number in
.ResTab.DelN.
delete all: Clear entire statistics table. The results can not be reac-
tivated.
.ResTab.DelN: Specification of the line number to be deleted.
4.2.2.14. Mode.Parameter.Presel.Cond ON, OFF
Mode.Parameter.Presel.DCor.Type auto, man., OFF
Mode.Parameter.Presel.DCor.Value 0.0...99.9