Banner EZ-SCREEN Low-Profile Safety Light Curtain Systems - Manual (Page 2)

Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
EZ-SCREEN LP
Instruction Manual
Table of Contents
Important
...
read this page before proceeding!
In the United States, the functions that EZ-SCREEN LP is
intended to perform are regulated by the Occupational Safety
and Health Administration (OSHA). Outside of the United States,
these functions are regulated by other agencies, organizations,
and governments. Whether or not any particular EZ-SCREEN
LP installation meets all applicable requirements depends upon
factors that are beyond the control of Banner Engineering Corp.
These factors include the details of how the EZ-SCREEN LP
is applied, installed, wired, operated, and maintained. It is
the responsibility of the purchaser and user to apply this
EZ-SCREEN LP System in full compliance with all relevant
applicable regulations and standards.
EZ-SCREEN LP can guard against accidents only when it is
properly installed and integrated into the machine, properly
operated, and properly maintained. Banner Engineering Corp.
has attempted to provide complete application, installation,
operation, and maintenance instructions. In addition, please
direct any questions regarding application or use of EZ-SCREEN
LP to the factory applications department at the telephone
number or addresses shown on the back cover.
In addition to OSHA regulations, several other organizations
provide information about the use of safeguarding devices.
Refer to the American National Standards Institute (ANSI),
the Robotics Industries Association (RIA), the Association for
Manufacturing Technology (AMT), and others (see below).
Banner Engineering Corp. makes no claim regarding a
specific recommendation of any organization, the accuracy or
effectiveness of any information provided, or the appropriateness
of the provided information for a specific application.
The user has the responsibility to ensure that all local, state,
and national laws, rules, codes, and regulations relating
to the use of this safeguarding system in any particular
application are satisfied. Extreme care is urged to ensure
that all legal requirements have been met and that all
installation and maintenance instructions contained in this
manual are followed.
Safety Standards Applicable to Use of EZ-SCREEN LP
See inside back cover for information pertaining to
ap pli ca ble U.S., European and International stan dards,
and where to acquire copies.
1. Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
1.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
1.2 Applications and Limitations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
1.3 Control Reliability: Redundancy and Self-Checking . . . . . . . . . . . . . . . . .2
1.4 Operating Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
2. Components and Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
2.1 Emitter and Receiver Models (Non-Cascadeable) – 14 mm Resolution . . .7
2.2 Emitter and Receiver Models (Non-Cascadeable) – 25 mm Resolution . .8
2.3 Cordsets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
2.4 Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
2.5 Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
2.6 Literature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
2.7 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
3. Installation and Alignment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
3.1 Mechanical Installation Considerations. . . . . . . . . . . . . . . . . . . . . . . . . . .21
3.2 Mechanical Mounting Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
3.3 Initial Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .30
3.4 Light Screen Initial Checkout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31
3.5 Electrical Interface to the Guarded Machine . . . . . . . . . . . . . . . . . . . . . .35
3.6 Preparing for System Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .38
3.7 Sensor “Swapability” and Emitter Hookup . . . . . . . . . . . . . . . . . . . . . . . .38
4. System Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
4.1 Security Protocol. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
4.2 System Configuration Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
4.3 Reset Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .43
4.4 Status Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .44
4.5 Normal Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .47
4.6 Periodic Checkout Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .47
5. Troubleshooting and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . .48
5.1 Troubleshooting Lockout Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . .48
5.2 Test Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .51
5.3 Electrical and Optical Noise . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .52
5.4 Servicing and Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .52
6. Checkout Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .53
6.1 Schedule of Checkouts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .53
6.2 Commissioning Checkout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .53
6.3 Shift/Daily Checkout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .54
6.4 Semi-Annual (Six-Month) Checkout . . . . . . . . . . . . . . . . . . . . . . . . . . . . .54
7. Cascadeable EZ-SCREEN LP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
7.1 Overview of Cascading. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
7.2 Cascadeable Emitter and Receiver Models – 14 mm Resolution . . . . . .56
7.3 Cascadeable Emitter and Receiver Models – 25 mm Resolution . . . . . .57
7.4 Determining Interconnect Cordset Lengths . . . . . . . . . . . . . . . . . . . . . . .58
7.5 Response Time for Cascaded Light Screens . . . . . . . . . . . . . . . . . . . . . .59
7.6 Cascaded Sensor Configuration Settings. . . . . . . . . . . . . . . . . . . . . . . . .61
7.7 Configuration for Cascaded Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .62
7.8 Emergency Stop Buttons and Devices . . . . . . . . . . . . . . . . . . . . . . . . . . .62
7.9 Positive-Opening Safety Interlock Switches . . . . . . . . . . . . . . . . . . . . . .64
7.10 Remote Fixed Blanking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .66
Appendix A. Bracket Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . .69
Glossary of Terms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .70
Safety Standards and Regulations . . . . . . . . . . . . . . . . Inside Back Cover
Declaration of Conformity. . . . . . . . . . . . . . . . . . . . . . . . Back Cover
Certificate of Adequacy
The EZ-SCREEN LP Instruction Manual (p/n 140044) satisfies
the requirements of Machinery Directive 2006/42/EC, Safety of
Machinery, Section 1.7.4 ─ Instructions.