E-flite Extra 260 3D 480 ARF - Manual (Page 31)

1 E-flite Extra 260 480 ARF Assembly Manual
Control Throws
 1. Turn on the transmitter and receiver of your aircraft.
Check the movement of the rudder using the transmitter.
When the stick is moved right, the rudder should also
move right. Reverse the direction of the servo at the
transmitter if necessary.
 2. Check the movement of the ailerons using the
transmitter. When the stick is moved right, the right
aileron will move up and the left aileron will move
down. Reverse the direction of the servo at the transmitter
if necessary.
 3. Check the movement of the elevator with the radio
system. Moving the elevator stick down will make the
airplane elevator move up.
 4. Use a throw gauge to adjust the throw of the elevator,
ailerons and rudder. Adjust the position of the pushrod
at the control horn, or the travel/endpoint adjustments
of your computer transmitter, to achieve the following
measurements when moving the sticks to their endpoints.
The control throw measurements are taken at the widest
point on the surface.
Low Rate High Rate
Ailerons:
Up 3 /
4
-inch (19mm) 1 1 /
2
-inch (38mm)
Down 3 / 4
-inch (19mm) 1 1 / 2
-inch (38mm)
Elevator:
Up 3 / 4
-inch (19mm) 1 1 / 2
-inch (38mm)
Down 3 /
4
-inch (19mm) 1 1 /
2
-inch (38mm)
Rudder:
Right 1 1 /
2
-inch (38mm) 2 1 /
2
-inch (64mm)
Left 1 1 /
2
-inch (38mm) 2 1 /
2
-inch (64mm)
These are general guidelines measured from our own
flight tests. You can experiment with higher rates to
match your preferred style of flying