SCHOEPS KFM 360 - Manual (Page 16)

Monitor / Presets
monitoring. Selector switch 3 allows the fol-
lowing options to be chosen:
1. KFM 360 with frequency response cor-
rection applied
2. Figure 8s with frequency response cor-
rection applied
3. L and R (FRONT PANORAMA not used;
no center channel signal available)
4. L and R (FRONT PANORAMA active)
5. Center channel
6. LS and RS without low-pass filter
7. LS and RS with low-pass filter
The next two monitor settings allow the
effect of the delay to be monitored:
8. LS channels with low-pass filter: left
channel with delay / right channel with-
out delay
9. SR channels with low-pass filter: left
channel with delay / right channel with-
out delay
10. KFM 360 with no frequency response
correction applied
11. Figure 8s with no frequency response
correction applied
12. Additional Low-Frequency Channel (LFE)
Buttons and display for preset functions
Storing and Recalling Presets
Certain groups of settings will probably
reveal themselves as your favorite ways of
using the DSP-4P. To set these up rapidly,
the unit is capable of memorizing ten groups
of settings and of calling them up instanta-
neously as "presets" 0 through 9.
Please note: The groups of stored set-
tings include the position of the five main
knobs in their primary functions, all of which
are controlled in the “green mode”: FRONT
pattern, FRONT PANORAMA, REAR pat-
tern, REAR DELAY and REAR SLOPE/Hz.
The settings of the secondary functions are
not stored.
Storing presets:
The numeric display will always show the
number of the most recently recalled or
stored preset. The current settings will be
stored as that number of preset whenever
the "Store" button is pressed. If a group of
settings has been associated with a given
preset number, a small red point will light up
within the display alongside the numeral.
If you intend to store a group of settings
as a certain preset number, press the
“store” button and keep it pressed while
using the up and down buttons to find the
desired number. If then you release the
"store" button, the settings will be stored as
the indicated preset. To store a group of
settings as the preset number which is
already being displayed, merely press and
release the “store” button.
Recalling presets
Stored presets are recalled simply by
pressing the "Up" and "Down" buttons until
the desired preset number appears. The
current knob settings are replaced immedi-
ately by the stored settings of the indicated
preset number.
16