ADS Environmental Services IntelliServe 2.8.1 950026A7 - Manual (Page 275)

Data Entities B-7
CONFIDENTIAL – Covered by ADS Terms of Use and Confidentiality Agreement in Contract
© 2010 ADS LLC. All Rights Reserved.
PIPE_WIDTH
HT
Pipe Width This represents the width of the pipe at
which the sensors are installed (defined by
the System Administrator).
PRESSK
HT
Pressure
Compensation This represents the value applied to the
pressure depth reading to compensate for
differences between the pressure depth and
ultrasonic depth measurements taken at the
same monitoring point.
PRESSK2
HT
Pressure
Compensation2 This represents the value applied to the
pressure depth reading to compensate for
differences between the pressure depth and
ultrasonic depth measurements taken at a
second monitoring point.
PTEMP
HT
Pressure
Connector
Temperature This represents the temperature at the
pressure sensor connector.
PUMP_1 through
PUMP_8
HT
(detected by monitor)
Pump On/Off
Times These events indicate that a pump station
pump has turned on(1) or off(0).
Q_A1
 Q_A12 HT
Analog Input
Quantity These represent the quantity data values
returned from an analog input device.
Q2THRESHOLD
HT
Quantity
Threshold This represents a quantity threshold for the
second monitoring point calculated by the
monitor based on historical flow patterns.
It is updated continuously based on flow
conditions at the monitoring point.
Typically, QTHRESHOLD is set to 25 to
30% below the normal flow rates at the
monitoring point. If the monitor readings
fall below the threshold, IntelliServe
generates a Flow Loss (detected by
monitor) alarm.
QAVERAGE_DRY_DAY
HT
Average Flow
Quantity for Dry
Days This represents the typical dry curve for
weekends and weekdays for that site,
based on the data collected most recently.
IntelliServe updates this value
automatically based on historical trends.
This entity is used in the data scrubbing
process.