Bio-Rad ChromLab™ Software - Manual (Page 71)

System Settings
User Guide | 69
System Settings
The System Settings dialog box enables you to customize your system. From this
dialog box you can
 Set the delay volume
 Control the flow rate to prevent overpressure
 Enable remote access to ChromLab from an iPad, Android device, or
another PC
 Reset the trace settings, the minimum and maximum y-scale values, and
the trace colors in the chromatogram to their factory default settings
 Enable or disable external detectors that are connected to the NGC
instrument via a SIM device
 Enable or disable the ability to send UV signals to external devices that are
connected to the NGC instrument via a SIM device
 Set air sensors to detect either end of sample or end of buffer
 Enable the system to send email messages about system events to a list of
users
 Set a unique name for the NGC system
Note: This dialog box is accessible in manual mode. The settings are saved
and the fraction collector is also synchronized in method runs.
Delay Volume Tab
Delay volume is the volume of plumbing between the UV detector and the fraction
collector drophead and/or the outlet valve. It indicates the delay between the
detection of the fraction’s UV peak and the time it takes for this peak to traverse the
volume of tubing and flow cells to the fraction tube into which it is collected.