Dell PowerEdge T610 - Manual (Page 33)

About Your System
33
E1A1D Control panel
USB cable not
detected.
Check cable.
USB cable to the control
panel is missing or bad. Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help."
E2010 Memory not
detected.
Inspect DIMMs.
No memory was detected
in the system. Install memory or reseat
memory modules. See
"Installing Memory
Modules" or
"Troubleshooting System
Memory."
E2011 Memory
configuration
failure. Check
DIMMs.
Memory detected, but is
not configurable. Error
detected during memory
configuration. See "Troubleshooting
System Memory."
E2012 Memory
configured but
unusable.
Check DIMMs.
Memory configured, but is
unusable. See "Troubleshooting
System Memory."
E2013 BIOS unable to
shadow memory.
Check DIMMs.
The system BIOS failed to
copy its flash image into
memory. See "Troubleshooting
System Memory."
E2014 CMOS RAM
failure. Power
cycle AC.
CMOS failure. CMOS
RAM not functioning
properly. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
E2015 DMA Controller
failure. Power
cycle AC.
DMA controller failure. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 33 Tuesday, September 15, 2009 10:08 AM