HP 9200c User Manual
Page 29
When you touch FAX on the control-panel display, the following screen appears.
4
1
2
3
9
8
5
6
7
1
Fax recipients list
2
One-touch speed-dial buttons
3
Configure button
4
Speed Dial button
5
Remove button
6
Notify button
7
Settings button
8
Next Number button
9
Phone Book button
Follow these instructions to send a fax.
1. Place the document face-up in the ADF or face-down on the scanner glass.
2. Touch FAX on the control panel.
3. Use the control-panel keypad to type the fax number(s) to which you want to send the
document, or use one of the one-touch buttons (see the following section for instructions
on setting up the the one-touch buttons).
NOTE
If you are sending to more than one fax number, touch Next Number to move down to a
new line and type the next number.
4. Touch Start to send the fax. Status messages show the progress of the fax operation.
NOTE
If the system administrator has enabled billing codes, you might be prompted for a billing
code after you touch Start. The fax is not sent until the billing code has been typed.
ENWW
Sending documents
23