Dell PowerVault TL4000 User Manual
User's guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Read this first
- Contents
- Figures
- Tables
- Safety and environmental notices
- Preface
- Chapter 1. Product Description
- Chapter 2. User Interfaces
- Chapter 3. Installation Planning
- Chapter 4. Installation and Configuration
- Using the Library Configuration Form
- Installing Your Library
- Configuring Your Library
- Choosing Your Configuration Method
- Using Factory Defaults as Your Configuration
- Configuring Your Library using the Web User Interface
- Establishing Remote Access to Your Library
- Logging on to the Web User Interface
- Verifying/Updating Firmware
- Choosing General Library Settings
- Choosing the Number of Logical Libraries for Your Library
- Entering Path Failover Feature Activation Key
- Setting Up Encryption
- Choosing Drive(s) Interface Identification/Settings
- Entering Library Network Settings
- Entering User Access Information using the Web User Interface
- Entering Date and Time using the Web User Interface
- Configuring Logs and Traces using the Web User Interface
- Entering Email Notification Information using the Web User Interface
- Configuring SNMP settings
- Testing encryption configuration for Library Managed encryption
- Restoring Factory Default Settings using the Web User Interface
- Logging out of the Web User Interface
- Configuring Your Library using the Operator Control Panel
- Preparing the Host
- Verifying the Connection
- Cartridge magazines
- Chapter 5. Operations
- Operator Control Panel Navigation
- Operator Control Panel Menu Tree
- Web User Interface Menus
- Monitor Library Menu
- Manage Library Menu
- Configure Library Menu
- Configure Library: General
- Configure Library: Logical Libraries
- Configure Library: Path Failover
- Configure Library: Encryption
- Configure Library: Drives
- Configure Library: Network
- Configure Library: User Access
- Configure Library: Date & Time
- Configure Library: Logs & Traces
- Configure Library: Event Notification
- Configure Library: SNMP
- Configure Library: Save/Restore Configuration
- Service Library Menu
- Service Library: Clean Drive
- Service Library: Advanced Diagnostics (for Service Personnel Only)
- Service Library: View Logs
- Service Library: View Drive Logs
- Service Library: Save Drive Dump
- Service Library: Perform Diagnostics
- Service Library: Key Path Diagnostics
- Service Library: Upgrade Firmware
- Service Library: Reboot
- Import and Export Media during Normal Library Operation
- Configuring I/O Stations and Reserving Slots
- Chapter 6. Using Ultrium Media
- Chapter 7. Troubleshooting
- Chapter 8. Error codes
- Chapter 9. Service Procedures
- Chapter 10. Check, Adjust, Remove, and Replace
- Tools Required
- Electrostatic Discharge
- Relocating Your Library
- Removing/Installing/Adding a Tape Drive Sled
- Replacing a Power Supply
- Replacing a Library Controller Card
- Replacing Cartridge Magazines
- Replacing the Library Enclosure
- Preparing the Defective Library for Replacement
- Unpacking and Preparing the Replacement Library Enclosure
- Installing your drive in the replacement library enclosure
- Swapping Power Supplies
- Swapping Library Controller Cards
- Swapping Cartridge Magazines
- Installing the Replacement Library Enclosure
- Completing the Installation of the Replacement Library Enclosure
- Returning the Defective Library Enclosure
- Appendix A. SCSI Element Types, SCSI Addresses, and Physical Configurations
- Appendix B. TapeAlert Flags
- Appendix C. Sense Data
- Appendix D. Enabling LUN Support in Linux
- Appendix E. Notes on IPv6 Compatibility with Windows 2003/XP and 2008/Vista
- Appendix F. SNMP Status MIB Variables and Traps
- Appendix G. Library Configuration Form
- Appendix H. Accessibility
- Glossary
- Index