3 resolving a link protocol mismatch, 4 resolving cli connectivity problems, 5 recovery from non-responsive 10gbe ptm cli – Dell POWEREDGE M1000E User Manual
Page 25: 6 recovery from a software update failure, Resolving a link protocol mismatch, Resolving cli connectivity problems, Recovery from non-responsive 10gbe ptm cli, Recovery from a software update failure, Section 5.5, “recovery from non-responsive 10gbe
Rev 1.00
25
chassisaction –m switch-<n> powercycle
where <n> is the switch number [1-6].
5.3
Resolving a Link Protocol Mismatch
Log in to 10GbE PTM CLI and run the “show port link” command. Check the status of the down-
link and uplink in the relevant port to identify the mismatch – see
for details.
5.4
Resolving CLI Connectivity Problems
Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch-<n> powercycle
where <n> is the switch number [1-6].
5.5
Recovery From Non-Responsive 10GbE PTM CLI
Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch-<n> powercycle
where <n> is the switch number [1-6].
5.6
Recovery From a Software Update Failure
1. Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch-<n> powercycle
where <n> is the switch number [1-6].
2. Restart the software update process.