Dell POWEREDGE M1000E - Manual (Page 22)

Software User’s Manual Rev 1.00
22
4 Operating Procedures
4.1 Procedure for Updating Software
The 10GbE PTM consists of three PhyX® devices and a micro-controller (CPU). This procedure
describes how to update both CPU SW & PhyX® FW using a single .pfw binary file.
The 10GbE PTM is delivered with the latest firmware available at the time of production. New fir-
mare versions will be posted on the Dell support page. The latest firmware can be found at:
http://support.dell.com/support/
Step 1 Download the 10GbE PTM firmware .zip file and extract the .pfw binary file.
Step 2. Connect to the 10GbE PTM using an SSH Client as described in Section 2, “Connecting to
the 10GbE PTM CLI,” on page 9 .
Step 3. From the CMC command line, connect to the 10GbE PTM CLI. Enter:
Note: At least 20 seconds must have passed since the last power cycle of the 10GbE PTM
module before running the following connect command.
$ connect switch-<n>
where <n> is the number of the switch -- 2 in our example.
The prompt should change to #.
Step 4. To start the upgrade process, run the command:
# copy image from-file
The system will now wait for a ".pfw" file to be transferred from the SSH client.
Step 5. In your SSH client, initiate file transfer by pulling down the Transfers menu and clicking Send
Files. Provide the path to the ".pfw" file and send it.
Figure 13: Transferring the .pfw File