Lubrication, Recommended accessories – Craftsman 113.24181 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LUBRICATION
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrication.
1.
Lay the saw on its LEFT SIDE.
2.
Clean
the
following
parts
with
Craftsman
Gum
and
Pitch
Remover;
BEVEL
GEARS,
ELEVATION
WORM
AND TEETH, TILT WORM AND TEETH.
Lubricate
these
parts
and
other
bearing
points
indicated,
with SAE No. 20 or No. 30 engine oil.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
Bearing points in guard assembly, miter gauge and rip fence.
RECOMMENDED ACCESSORIES
IN CANADA, SEE YOUR LOCAL SIMPSONS-SEARS STORE
OR CATALOG FOR ACCESSORY SELECTION AND NUMBERS.
ITEM
CAT. NO.
ITEM
CAT. NO.
Retractable Caster Set ......................................... 9-22201 — 9-22209
7 In. Molding Head Set.................................................................... 9-3217
7 In. Molding Head Set.................................................................... 9-3218
7 In. Molding Head ............................................................................ 9-3214
Molding/Dado Insert for 7 in.
Dia. Molding or Dado Head ........................................................... 9-29995
Work Light ..........................................................................................9-2480
Work Light ......................................................................................... 9-2481
7 In. Dia. Adjustable Dado Head ..................................................... 9-3263
7 In. Dia. Dado Head ......................................................................... 9-3257
Blade Stabilizers ................................................................................9-4952
Sanding Wheel ................................................................................ 9-22723
Miter-Gauge Stop Rods....................................................................9-29924
Miter-Gauge Hold-Down Clamp ..................................................... 9-29928
Hold-Down Set ................................................................................... 9-3230
Taper Jig.............................................................................................. 9-3233
Universal Jig ..................................................................................... 9-3231
Power Tool Know How Handbook
Table Saws......................................................................................9-2918
The above recommended accessories'are current and were
'
available at the time this manual was printed.
27