Assembly – Craftsman 113.24181 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ATTACHING LEGS
1
.
Turn the saw upside down.
NOTE:
DO
NOT
LAY
IT
ON
THE
FLOOR
AS
THIS
MAY
SCRATCH
THE
TABLE
SURFACE.
PLACE
IT
ON STRIPS OF WOOD OR PARTS OF THE PACKING
MATERIAL.
2.
From among the loose parts, find the following
hardware:
16 Hex. Head Screws, 5/16 in.—18 x 5/8 in. long
16 Hex. Nuts, 5/16 in.—18 {approx, dia. of hole, 5/16
in.)
16 Hex. Head Screws, 1/4 in.-20 x 1/2 in. long
16 Hex. Nuts, 1/4 in.—20 (approx, dia. of hole, 1/4 in.)
8
Hex. Nuts, 1/2 in.—13 (approx, dia. of hole, 1/2 in.)
4 Leveling Feet
16 Lockwashers, 1/4 in. External Type (approx, dia. of
hole, 1/4 in.)
16
Lockwashers,
5/16
in.
External
Type
(approx,
dia.
of hole, 5/16 in.)
NOTE: The four stiffeners are identical. BE SURE TO
ATTACH
THE
SIDE
STIFFENERS
USING
THE
OUTER
HOLES
...
ATTACH
END
STIFFENERS
USING INNER HOLES.
3.
Insert screws through legs then through stiffeners.
Install lockwashers and nuts. DO NOT TIGHTEN.
4.
After all screws, washers and nuts are installed, tighten
all nuts.
5.
Install leveling feet.
6
.
Place saw in upright position.
Before proceeding with the assembly, the Table Insert and
Blade Squareness must be checked at this time.
CHECKING TABLE INSERT
2.
Insert should be flush with table top. Check as shown —
and adjust the four setscrews as necessary.