Qllli, Assembly – Craftsman 113.298761 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembly
2, Place saw on legs so lhai holes in bottom of saw line
up with holes in top of legs.
3. install screws, washers, lockwashers and nuts as
shown.
Ifyou mountthesaw on any otherbench, make sure that
there is an opening in the top of the bench the same size
as the opening in the bottom of the saw so that the
sawdust can drop through. Recommended working
height is 33 to 37 inches from the top of the saw table to
the floor.
7/16 DIA. HOLES
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
1. From among the loose parts find the following hard
ware: (Quantity indicated is for two extensions)
*8 Hex Hd. Screw 5/16-18 X 1-1/4
*8 Flat Washer
*8 External Lockwasher, 5/16
‘8 Hex Nut, 5/16-18
Items marked with an asterik (*) are shown actual size.
Qllli*
^ 5/16-18
X
1-1/4 IN
HEXHEAD SCREW
5/16-18
HEX NUT
5/16 IN EXTERNAL
LOCKWASHER
FLAT WASHER
12