Craftsman 113.298761 - Manual (Page 23)

4. SMPORTANT: Maasure the distance from end of
Motor shaft to Pulley. Mark this dimension down;
you will need it later when reinstaliing the Pulley.
5. Make sure blade is 90“to table, raiseitallthewayup.
6. Lift Motor until edge of washer is even with end of slot
tighten pivot screw. Inthis position, pull Motortoward
you {pins will slide out of Cradle) until Belt is TIGHT,
tighten the two Motor Base Ctamp Screws.
7. Loosen Pivot Screw slightly.
8. Lower the saw blade all the way down.
9. IMPORTANT: Motor Should pivot freely down­
ward as blade is lowered. If it does not, LOOSEN
the Pivot Screw some more.
10. Pivot Screw must be adjusted only tight enough to
allow Motor to pivot FREELY as blade is raised and
lowered. This will maintain constant tension on Belt.
11. Put your hand around the belt half way between the
two Pulleys and squeeze Belt until two sides of Belt
touch. The Motorshould movefreely as you squeeze
the Beit. If Motor does not move freely, Belt tension
must be readjusted.
INSTALLING BELT GUARD
Model 113.298721
1
.
2
.
3.
BELT
SUPPORT SBACKET I
;LT 6UAHD SUPPORT
EDGE OF WASHER
EVEN WITH END
OF SLOT
Remove the Belt and Motor Pulley.
Screws furnished with Guard are "Self Threading".
Screwthem into holesin Belt Guard Support Bracket,
then remove them.
Position Belt Guard Support Bracket and Belt Guard
Support as shown and install the screws. Make sure
Motor shaft is in CENTER of hole in Support.
10-32 K 1/7 IN.
SELF^THFtEAOING
SCREW
BELT GUARD
SUPPORT
INSTALLING BELT GUARD
Model 113.298761
1. Remove the Belt and Motor Pulley.
2. Screws furnished with Guard are Self Threading."
Screwthem into holes in Belt Guard Support Bradtel,
then rerrove them.
3. Position Beit Guard Support Bracket and Bett Guard
Support as shown and install the screws. Make sure
Motor Shaft is in CENTER of hole in support.
TWO HOLES CLOSEST
TOGETHER
10-32 X 1/2 IN.
• SELF-THREADING
SCREW
BELT GUARD
SUPPORT
BELT GUARD
SUPPORT BRACKET
23
BELT GUARD SUPPORT