Kontron AT8402 CLI - Manual (Page 146)

Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 6
4.3.1 show arp switch
This command displays the contents of the IP stack’s Address Resolution Protocol
(ARP) table. The IP stack only learns ARP entries associated with the management
interfaces - network or service ports. ARP entries associated with routing interfaces are
not listed.
Format show arp switch
Mode Privileged EXEC
IP Address IP address of the management interface or another device on the man-
agement network.
MAC Address Hardware MAC address of that device.
Interface
For a service port the output is Management. For a network port, the
output is the slot/port of the physical interface.
4.3.2 show eventlog
This command displays the event log, which contains error messages from the system.
The event log is not cleared on a system reset.
Format
show eventlog
Mode Privileged EXEC
File The file in which the event originated.
Line The line number of the event
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
NOTE: Event log information is retained across a switch reset.
4.3.3 show hardware
This command displays inventory information for the switch.
NOTE: The
show version
command and the
show hardware
command dis-
play the same information. In future releases of the software, the
show
hardware command will not be available. For a description of the
command output, see 4.3.4 “show version“ on page 4 - 6.
Format
show hardware
Mode Privileged EXEC
4.3.4 show version
This command displays inventory information for the switch.
NOTE: The
show version
command will replace the
show hardware
com-
mand in future releases of the software.
Format
show version