Kontron AT8402 CLI - Manual (Page 157)

AT8402 Utility Commands
Page 4 - 17 AT8402 CLI Reference Manual
4.3.10 show tech-support
Use the
show tech-support
command to display system and configuration
information when you contact technical support. The output of the
show tech-
support
command combines the output of the following commands:
• show version
• show sysinfo
• show port all
• show logging
• show event log
• show logging buffered
• show trap log
• show running config
Format show tech-support
Mode Privileged EXEC
4.3.11 show boardinfo post-status
This command displays the system power on self test status.
Format
show boardinfo post-status system
Mode Privileged EXEC
4.3.12 show boardinfo sensors
This command displays the current sensor readings. It can either display a compressed
list of all sensors or display full readings for a specified sensor. The <record-id> (of
SDR) for a specific sensor is displayed in the compressed list
Format
show boardinfo sensors
{<record-id> | brief}
Mode Privileged EXEC
NOTE: It might take a while to get an output of the “show boardinfo sensors brief”
command
4.3.13 show boardinfo event-log
This command displays the event log of the board management controller. It can either
display a summary (“info”) or a list of all existing event-log records, a list with most
recent records or a single record. The <record-id> (of SEL) is displayed in the list of
records.
Format
show boardinfo event-log {info | list [last <nr-of-most-recent-
entries> | <record-id>]}
Mode Privileged EXEC
NOTE: It might take a while to get an output of the “show boardinfo event-log list”
command
4.3.14 show boardinfo update-status
This command displays the status of the firmware update process for the IPMI
controller.