Mercedes-Benz C-Coupe 2012 COMAND Manual - Manual (Page 71)

Point of interest search near the current position
(example)
i The point of interest search is canceled
when 50 points of interest have been
found.
COMAND searches within a radius of
approximately 60 mi.
If COMAND fails to find a point of interest
within this radius, it extends its search
range to approximately 125 mi.
If COMAND finds one point of interest
within this radius, it finishes the search.
Once the search is completed, the point of
interest list is displayed.
Point of interest list
Introduction
The point of interest list displays the search
results for the selection made.
Point of interest list (example)
An entry contains the following information:
R an arrow that shows the linear direction to
the point of interest
R the linear distance to the point of interest
R the name of the point of interest
i The arrow and linear distance to the
destination are not visible if you have
entered a point of interest within a specific
city.
The arrow is also not shown when a point
of interest in the vicinity of the destination
has been entered.
Depending on the point of interest
selected, COMAND uses different
reference points in determining the linear
distance to the destination:
R vicinity of current position: the linear
distance is the distance of the point of
interest from the current vehicle
position.
R vicinity of destination: the linear distance
is the distance from the destination
entered to the point of interest.
Selecting a point of interest
The example has been selected in the point
of interest category BAR & RESTAURANT .
X Select the point of interest in the point of
interest list by turning cVd the COMAND
controller and press W to confirm.
The complete address of the point of
interest selected is shown.
Entering a point of interest
69
Navi
ga
tio
n
Z