Mercedes-Benz CL-Class 2007 - Manual (Page 393)

392
Controls in detail
Automatic transmission
Shifting from D or R to N
If you want to select neutral position N
with the transmission being in drive
position D or reverse gear R:
̈ With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
̈ Press the handle for electronic parking
brake (
୴ page 384).
̈ Move gear selector lever up to resis-
tance point when in drive position D or
down to resistance point when in
reverse gear R to select neutral
position N.
̈ Release the brake pedal.
Shifting procedure
The automatic transmission selects indi-
vidual gears automatically, depending on:
ț drive position D ( ୴ page 393) with
gear ranges ( ୴ page 398)
ț the selected program mode (C/S)
(
୴ page 399)
ț the position of the accelerator pedal
(
୴ page 396)
ț the vehicle speed
With drive position D selected, you can use
the steering wheel gearshift control
buttons (
୴ page 400) to influence trans-
mission shifting by:
ț limiting the gear range
ț changing gears manually
i When the vehicle needs to be moved with
the engine switched off and the transmission set
to neutral position N ((
୴ page 393), do not press
the handle for electronic parking brake.
! Allow engine to warm up under low load use.
Do not place full load on the engine until the op-
erating temperature has been reached.
Shift into reverse gear R or park position P only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.