Pridiom Floor and Ceiling PFCM183HX Remote Control Manual - Manual (Page 6)

9 9 10 10
Cooling /Heating/Fan operation
Ensure the unit is plugged in and power is
available.
1. Press the MODE button to select COOL, HEAT,
(cooling & heating models only) or FAN mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature can
O O O be set within a range of 62 F~86 F in 1 F
increments.
3. Press the FAN SPEEDbutton to select the
fan speed in four steps- Auto, Low, Med,or
High.
4. Press the ON/OFF button to start the
heat pump
In the FAN mode, the setting temperature is not
displayed in the remote controller and you are not able
to control the room temperature either. In this case,
only step 1, 3 and 4 may be performed.
NOTE
Auto operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the
desired temperature. The temperature can
O O O be set within a range of 62 F~86 F in 1 F
increments.
3. Press the ON/OFFbutton to start the
heat pump
1
1. In the Auto mode, the heat pump can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setting
temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3. If the Auto mode is not comfortable for you , the
desired mode can be selected manually.
NOTE
3
2
3
2
MODE FAN SPEED
M
AUTO
COOL
DRY
HEAT
FAN
TEMP.
SET
CLOCK
HOUR
1
4
AUTO
COOL
DRY
HEAT
FAN
TEMP.
SET
CLOCK
HOUR
MODE FAN SPEED
M
Dehumidifying operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature.
3. Press the ON/OFF button to start the
heat pump
The temperature can
O O O be set within a range of 62 F~86 F in 1 F
increments.
In the Dehumidifying mode, you can not switch the
fan speed. It has already been automatically controlled.
NOTE
Adjusting air flow direction
Use the SWING V button to adjust the desired
airflow direction.
When push the SWING V button, the horizontal
louver changes 6 degree in angle for each push.
Keep pushing more than 2 seconds, the louver
will swing automatically and give UP and
DOWN air flow.
NOTE: When the horizontal louver swing
or move to a position which would affect
the cooling or heating effect of the heat pump,
it would automatically change
the swing/moving direction.
1
3
2
MODE FAN SPEED
M
AUTO
COOL
DRY
HEAT
FAN
TEMP.
SET
CLOCK
HOUR