Rice Lake CLS-420 Cargo Lift Scale Installation Manual User Manual
Cls-420, Installation manual
Advertising
Table of contents
Document Outline
- Contents
- About this Manual
- Safety
- 1.0 Introduction
- 2.0 Scale Base Installation
- 3.0 Indicator Hardware Setup
- 3.1 Mounting the 420 Indicator
- 3.2 Cable Connections
- 3.3 Supplying Power to the Indicator From the Forklift Battery
- 3.4 Routing the Power/Serial Communications Cable
- 3.5 Supplying Power to the Two-Channel iQube Using a Lithium-Ion Battery
- 3.5.1 Lithium-Ion Battery Specifications
- 3.5.2 General Precautions
- 3.5.3 Charging the Lithium-Ion Battery
- 3.5.4 Calibrating the Lithium-Ion Battery
- 3.5.5 Battery Removal
- 3.5.6 Battery Disposal
- 3.6 Two-Channel iQube Junction Box
- 4.0 ABF Version
- 5.0 Configuration
- 6.0 Calibration
- 7.0 Repair Parts List
- 8.0 Appendix
- 8.1 Error Messages
- 8.1.1 Displayed Error Messages
- 8.1.2 Using the XE EDP Command
- 8.2 Status Messages
- 8.2.1 Using the P EDP Command
- 8.2.2 Using the ZZ EDP Command
- 8.4 ASCII Character Chart
- 8.6 Conversion Factors for Secondary Units
- 8.10 Regulatory Mode Functions
- 8.11 LED Functions
- 8.12 420 Indicator Specifications
- CLS-420 Digital Indicator Limited Warranty
- Daily Inspection Checklist for Lift Truck Scale Users