Rice Lake Mechanical Physician Scale with Handpost RL-MPS-30 (KG Only) - Manual (Page 11)

Mechanical Physician Scale Installation and Operation Instructions - Hand Post Installation 7
3.0 Hand Post Installation
The Rice Lake Mechanical Physician scale comes with a hand post to add in balancing a patient while on the
scale. Use the following steps to install the hand post to the scale.
1. Unscrew the four hex head screws from the scale base and set the screws and washers aside.
Figure 3-1. Unscrew Hex Head Screws From Scale Platform
2. Position the hand post over the screw holes on the scale platform making sure that the washer is set
between the hand post base and the screw.
Figure 3-2. Position Hand Post
3. Tighten all four hex head screws with the wrench that has been provided.
Figure 3-3. Tighten Hex Head Screws
D o not attempt to transport the scale by the hand post. Serious injury could occur to the
scale and to the operator .
Warning