Rice Lake Mechanical Physician Scale with Handpost RL-MPS-30 (KG Only) - Manual (Page 9)

Mechanical Physician Scale Installation and Operation Instructions - Installation Instructions 5
2.3 Height Rod Installation
The Mechanical Physician Scale comes with a height rod. Use the following steps to install the height rod.
1. Insert the back side slotted holes of the height rod into the two bolts on the front side of the pillar as
shown in Figure 2-7. One is located at the top of the pillar and the other towards the bottom of the pillar.
.
Figure 2-7. Attach the Slotted Screw Location onto the Pillar Bolt Location
2. Use the enclosed wrench to tighten the two stainless steel hex-head screws, but ensure not to over
tighten.
3. To raise or lower the height rod, press the red button at the top of the height rod and raise up or down.
Figure 2-8. Height Rod Button
Slotted holes
Press red button to raise
or lower height rod.