Operating instructions: remote control functions – Outdoor Great Room GE-94 User Manual

Page 8

Advertising
background image

8

90236 GE50-94 REV A 8-3-12

OPERATING INSTRUCTIONS:

REMOTE CONTROL FUNCTIONS


This appliance can be operated by both remote control and manual buttons located on the side of the fire box. Once the
unit has been properly connected to a grounded electrical outlet, turn on the main power switch located on the right-hand
side of the appliance. A beep should be heard when the power is first switched on.

CAUTION !

The unit’s power cord must be connected to a properly grounded and protected 120V outlet.

Always use ground fault protection where required by the electrical code.

WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged,
please call a qualified service technician to inspect and to replace any part of the electrical system

If necessary.


NOTE! To use both remote and manual function

the main power switch must be in “ON” position.


Operating by Manual Button

MANUAL ON/OFF SWITCH
This switch turns heater on/off, and permits / prohibits use of remote
and panel push buttons.

FLAME BUTTON
The fire has four flame effects, by pressing the flame effect button the
unit will cycle through each effect.

HEATER BUTTON
Press once turns 750W

power on. (Pilot lights illuminated ●○)

Press again turns 1500W

power on (Pilot lights illuminated ●●)

Press third time turns heater off. (Pilot lights illuminated ○○)

Operating by Remote Handset

Make sure the battery are installed properly in the remote control.

The effective range of the remote control is up to 4 meters or 13 feet.

ICON

TITLE

FUNCTION

POWER

Press once turns appliance on. Press again turns appliance off.

FLAME

The fire has four flame effects, by pressing the flame effect button the
unit will cycle through each effect.

HEATER

Press once turns 750W

power on. (Pilot lights illuminated ●○)

Press again turns 1500W

power on (Pilot lights illuminated ●●)

Press third time turns heater off. (Pilot lights illuminated ○○)

TEMP

Digital display shows the TEMP setting 23°C (73°F) (default), with 14
settings circle from “OFF”, “16°C” to ”28°C” (61°F to 82°F).
The TEMP will increase by 1°C/F up to 28°C(82°F) when pressed

each time.

By pressing the TEMP for 3S, the digital display can switch

between °C and °F.

TIMER

Cycles from OFF, 0.5H, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, to 9H.

BACK LIGHT

By pressing the backlight button the unit will cycle through 12 Colors,

a color-cycle mode, and OFF setting.

Advertising
This manual is related to the following products: