PDR Mounts pdm120thn - Manual

Parts Configuration Chart Features
Mo unting points for panel display models
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the
mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and
airflow.
Low profile 15/16” (23.7mm)
1 ½” & 3” Vertical height adjustment
16" or 24" stud mounting points
Easy installation
Lateral movement from center
for better viewing position.
Wall mount bracket…1 pc
A
B
D
E
J
O
N
M
K
L
5 mm x 16 mm Phillip screws…4 pcs
5/16" x 2 1/2” Lag bolts …4 pcs
6mm x 40mm Philips screws...4pcs
8mm x 40mm Philip screws...4 pcs
Plastic spacer...4 pcs
Display bracket .... 2 pcs
G
F
C
6 mm x 16 mm Phillip screws…4 pcs
5/16" Flat washers…4 pcs
8mm x 16mm Philip screw...4 pcs
H
1
Model # 120 = 24”
Square multi-mount washers...4 pcs
Model # 120 = 14”
24”
I
Panel Display mounting points
14”
Fig 1
All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
We are not liable for improper installation that results in damage to mounts, adapters or presentation equipment.
Mounts by
A division of David Engineering & Mfg. Inc.
Model: PDM120THN PANEL DISPLAY MOUNT
Gravity lock... 2 pc
Top
Bottom
Thank you for purchasing the PDR panel display mount.
To insure the correct usage, please read and follow the instruction manual throughly. Please store the instructions in a safe
place for future reference.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the
weight of both the panel display and the wall mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
5 mm x 40 mm Phillip screws...4 pcs
4 mm steel flat washer... 4 pcs
4mm x 16 phillips screw... 4pcs
1 ½’” & 3”VERTICAL
HEIGHT ADJUSTMENT