Ryobi TS1351 - Manual (Page 26)

Page 26
CUTTING WARPED MATERIAL
See Figures 36 and 37.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 36.
If the warped material is positioned the wrong way as shown
in figure 37, it will pinch the blade near the completion of the
cut.
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed or
warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 38.
When cutting wide workpieces, such as 51 mm x 152 mm (52
in. x 6 in.), boards should be clamped with a C-clamp as
shown in figure 38.
OPERATION
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save right end of cut
33.85 °
33.85 °
33.85 °
33.85 °
Fig. 36
RIGHT
0
22.5
30
15
31.6
22.5
30
15
31 .6
4 5 45
0
22.5
30
15
31. 6
22.5
30
15
31.6
4 5 45
WRONG
Fig. 37
3
4 55 3 00
1 55
11 5
33 0
3 3 0
31.6 31.6
22.5 22.
5
22.522 .
5
22 .
5
15
30
45
3
1 55
00
4 5 5
DAN GER KEE P HA NDS A WAY FROM BLADE
Fig. 38
WIDE
BOARD