Brookfield DV-I Prime User Manual
Page 26
Brookfield Engineering Laboratories, Inc.
Page 26
Manual No. M/07-022-D0613
When Temp Offset is enabled the temperature units display will be underlined.
Cp 0.0
70.1°F
0.0 RPM
% 0.0
Figure II-33
NOTE: Temp. offset remains active when unit is powered down and powered up again.
II.10 Print Modes
NOTE:
The print key is inactive when the motor is off. The printer must be attached to
the appropriate rear panel output connector. See Appendix G.
1. Press the print key once (less than 3 seconds) and DV-I PRIME will print one standard
line to a printer through the serial port output.
Figure II-34 shows examples of the print strings for CGS and SI units.
For the case of CGS units with non-exponential results:
and CGS units with exponential results.
Similarly, for SI units with non-exponential results.
and SI units with exponential results.
M = Torque T = Temperature Z = Time
1
10
20
30
40
50
60
70
80
RPM=XXX M=XXXXX S=XX %=XXX.X cP=XXXXX D/CM2=XXXXX 1/SEC=XXXXX T=XX.XC ZXX:XX
RPM=XXX M=XXXXX S=XX %=XXX.X cP=XXXeX D/CM2=XXXeX 1/SEC=XXXXX T=XX.XC ZXX:XX
1
10
20
30
40
50
60
70
80
RPM=XXX M=XXXXX S=XX %=XXX.X mPas=XXXXX N/M2=XXXXX 1/SEC=XXXXX T=XX.XC ZXX:XX
1
10
20
30
40
50
60
70
80
1
10
20
30
40
50
60
70
80
RPM=XXX M=XXXXX S=XX %=XXX.X mPas=XXXeX N/M2=XXXeX 1/SEC=XXXXX T=XX.XC ZXX:XX
Figure II-34
2. To initiate a continuous print mode, press and hold the print key for more than 3 seconds
and the following screen appears.