Programming transmitters – Inovonics FA464DR User Manual

Page 6

Advertising

hc:21-Nov-03

Programming transmitters:

Without the FA116 programmer:

1. Refer to Appendix A to determine available default parameters.

2. Select a point number which matches desired transmitter parameters.

3. Press

the

Advance Button on the FA464DR until the Transmitter Number Display shows the

desired transmitter number. (Hold down the Advance Button for auto repeat.) The Programming

LED will blink if the point has not been programmed. If a transmitter has already been programmed to

that channel, the LED will be on steady.

4. Connect the programming cable to the transmitter and then to the Transmitter Programming Port

on the FA464DR.

5. Press the transmitter reset button. (Refer to.) When the transmitter is successfully programmed, the

receiver will emit a single "deedle" tone and the Programming LED will be on solid. (It may be

necessary to press the transmitter reset button more than once, if the receiver is "busy" with signals

from other transmitters.)

With the FA116 programmer: Up to 64 transmitters can be selected, programmed and deleted. The

programmer allows installers to configure receiver parameters and output options. Point status and signal

strength can be observed. Receiver outputs can be activated for testing and faults can be cleared.

Refer to FA116 programming documentation.

Advertising