Cadillac 2012 SRX - Manual (Page 139)

Black plate (7,1) Cadillac SRX Owner Manual (Include Mex) - 2012
Instruments and Controls 5-7
Headlamp Washer
For vehicles with headlamp
washers, they are located to
the side of the headlamps.
The headlamps must be on in
order to use the headlamp washers.
If the headlamps are not on, only
the windshield will be washed.
Pull the wiper lever toward
you and hold briefly to activate.
The headlamp washers will spray
once, pause, and spray again.
The headlamp washer will spray
again after five windshield wash
cycles.
See Washer Fluid on page 10‑21 for
information on filling the windshield
washer fluid.
Compass
The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass receives
its heading and other information
from the Global Positioning
System (GPS) antenna, StabiliTrak,
and vehicle speed information.
Avoid covering the GPS antenna
for long periods of time with
objects that may interfere with
the antenna's ability to receive a
satellite signal. See Multi-Band
Antenna on page 7‑18 for the
location of the vehicle's antenna.
The compass system is designed
to operate for a certain number of
miles or degrees of turn before
needing a signal from the GPS
satellites. When the compass
display shows CAL, drive the
vehicle for a short distance in an
open area where it can receive a
GPS signal. The compass system
will automatically determine when a
GPS signal is restored and provide
a heading again. See Compass
Messages on page 5‑33 for more
information on the messages that
may be displayed for the compass.
Clock (Analog Clock)
The analog clock is located on the
instrument panel above the radio.
The clock is not connected with any
other vehicle system and runs by
itself. To adjust the clock:
1. Locate the adjustment buttons
directly below the clock face.
2. Push and hold either adjustment
button to advance or reverse the
clock hands. Holding the buttons
down will cause the clock to
advance faster. Release the
buttons before reaching the
desired time.
3. Push and release the buttons to
increase the time by one minute
increments until the desired time
is reached.