Carl Goldberg GPMA1926 Monster Pitts Electric ARF User Manual
Page 10
Advertising
10
9.
Reinstall the stab in the fuselage using the
marks to realign.When satisfied with the fit,
glue in place using Ultra Set 30 minute
epoxy. Apply a thin film and slide into place
Use alcohol to clean the excess epoxy.
8.
Remove the stab and carefully cut the covering
about 1/8” inside the mark you made. Be
careful not to cut into the wood as this will
weaken the stab. Remove the covering both
top and bottom.
11.
Install the fin in the slot and mark both side
where it meets the fuselage.
10.
Locate the fin and rudder and three CA
hinges.
12.
Remove the covering cutting about 1/8” inside
your marks. Be careful not to cut into the wood
Remove on both sides.
13.
Re-install the fin and glue in place using
Ultra Set epoxy.
Advertising