Carl Goldberg GPMA1926 Monster Pitts Electric ARF - Manual (Page 15)

15
Motor Mounting
1. Because there are so many different styles and
types of motors it is impossible to cover them
all. The kit comes with a 3/8” square motor
mount to use with the beam type gear boxes.
and a spacer for use with some of the axial
motors. Your installation may vary.
2. Our installation will show the AXI 2820 motor
installed.
3. Center the motor on the firewall and mark the
location of the mounting holes.
4. This motor required the center of the firewall to
be opened up to allow the rear shaft to pass
through the firewall.
5. Route the wires from the motor back into the
fuselage through the opening in the side of the
motor box.
6. Take a scrap of paper and tape to the side of
the fuselage and make a mark over the center
of the cowl mounting block. Do this on the
other side and the bottom (three places).
Note:
Motor shown for reference only, not includ-
ed in kit.