Changing a cycle or option setting, During the first minute of a cycle, After the first minute of a cycle – Whirlpool 930 User Manual
Page 15: Adding an item during a cycle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S E T T I N G T H E C O N T R O L S
Changing a cycle or option setting
During the first minute
of a cycle
1. Press new Cycle and/or Option pads.
2. Check the detergent dispensers. They
must be filled properly for the new cycle.
After the first minute
of a cycle
1. Press Cancel/Drain. A 2-minute drain
cycle starts. Wait for drain cycle to finish.
2. Press a new Cycle pad.
3. If desired, press one or more Option
pad(s).
4.
Check the detergent dispensers. They
must be filled properly for the new cycle.
T E MP
I
A IR D RY
WA SH
I
Adding an item during a cycle
You can add an item to the dishwasher
anytime before the main wash portion of a
cycle. See the “Setting the Controls” section.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3.
Close the door, but
do not
latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4.
Close the door firmly until it latches. The
dishwasher resumes the cycle.
15