Install reverse osmosis eaucet, Step 2-lnstall reverse osmosis drain -10, Step 5 - install ro faucet – Kenmore ULTRAFILTER 650 625.38556 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising

step 5 - Install RO Faucet

SELECT LOCATION OE REVERSE OSMOSIS
EAUCET MOUNTING HOLE

You will need to select the location of the Reverse
Osmosis Faucet. You have three options to choose from:

• Use the existing sink top hole for the spray hose or

soap dispenser (Must be 1-1/4" in diameter)

• Drill a new hole in the sink
• Drill a new hole in the countertop next to the sink

1. Determine where you are going to install your Reverse

Osmosis Faucet.

2. Check to ensure the Reverse Osmosis faucet will

mount flat against the mounting surface.

3. Visually review the routing of the tubes from the

Reverse Osmosis filter assembly to the faucet. Check
to ensure there is adequate tube routing space
between the faucet and filter assembly.

4. If drilling is needed, drill a 1-1/4" diameter hole in the

mounting surface.
IMPORTANT: Drilling holes into countertops and
sinks should only be performed by a qualified installer
who is certified for drilling such materials. Drilling of
surfaces made of stone or solid surface materials such
as granite, marble, Corian™ or other plastic resin prod
ucts or sinks made of porcelain and stainless steel may
cause permanent, irreparable damage to the sink or
countertop surface.

INSTALL REVERSE OSMOSIS EAUCET
1. Locate and organize your RO faucet install parts. Refer

to Figure 13.

2. Mount faucet base to sink hole until the faucet base is

square against the sink surface. The rubber washer
should be between the sink surface and the faucet

base.

3. Tighten the toggle bolts until the base is firmly mount

ed to the sink surface. Do not overtighten.

4. Feed a length of 3/8" blue tubing up through the hole

and connect to the 3/8" quick connect fitting on the

bottom of the faucet. See Figure 14.

5. Feed a length of 1/4" red tubing up through the hole

and connect to the 1/4" barb on the bottom of the
faucet. See Figure 14.

6. Connect the length of 3/8" black tubing to the 3/8"

barb on the bottom of the faucet. See Figure 14.

faucet

1/4 turn to connect
faucet ba.se

Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com

Advertising